L-LB03

  Knight Rider NON-Sequential Dual Intensity LED Light Bar with Flashing Brake Alert

$26.95

NON-Sequential

12 Dual Intensity LEDs

with Flashing Brake Alert

• 12 high power dual intensity LEDs.
• In running light mode the LEDs are on in low intensity mode.
• When the brake is applied the LED will flash for approximately 5-6 seconds then go to a solid on state until the brake is released.
• Both modes, running and brake, have been designed to create the maximum visibility.
• The unit comes pre-taped with 3M double sided tape for easy mounting to any flat surface.
• Simply connect the black wire to any ground wire, the Red wire to your exiting brake light wire and the blue wire to an existing running light power source.
• Works with any 12VDC system, no load equalizer or resistors required. 
• Dimensions: 4.7" long x .7" wide x .7" high.

  L-LB02

  Knight Rider Sequential Dual Intensity LED Light Bar with Flashing Brake Alert

$26.95

Sequential

12 Dual Intensity LEDs

with Flashing Brake

• 12 high power dual intensity LEDs.
• In running light mode the LEDs sequence from side to side in a "Knight Rider" sequence.
• When the brake is applied the LED will flash for approximately 5-6 seconds then go to a solid on state until the brake is released.
• Both modes, running and brake, have been designed to create the maximum visibility.
• The unit comes pre-taped with 3M double sided tape for easy mounting to any flat surface.
• Simply connect the black wire to any ground wire, the Red wire to your exiting brake light wire and the blue wire to an existing running light power source.
• Works with any 12VDC system, no load equalizer or resistors required. 
• Dimensions: 4.7" long x .7" wide x .7" high.